This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Deano400
Pages: 1 ... 22 23 [24] 25 26 ... 31
346
« on: October 24, 2018, 08:39:28 PM »
Thing is only two out of the four have them. They are listed under different part numbers.
347
« on: October 24, 2018, 08:33:02 PM »
Can anyone enlighten me as to what the divots are for in two of the carburettor insulators?
348
« on: September 04, 2018, 09:45:56 AM »
Thanks Julie. Definitely looks untouched. I wonder if in the past the shaft has been hammered out shearing the pin? Mine seems quite solid so I think it'll be a risk hammering. Still looks like the drill for me.
349
« on: September 04, 2018, 07:56:25 AM »
Thanks Laverda120, looks like I'll be drilling one way or another.
350
« on: September 03, 2018, 09:17:09 PM »
Thanks Julie, will give it a try.
351
« on: September 03, 2018, 08:53:19 PM »
Hi, can anyone advise on the following before I break something.
Would like to get the butterfly shaft out so I can overhaul all the parts. The shaft rotates freely but has little lateral movement. I am assuming that it is held in by a pin (see pic).
Is this something I have to drill out to remove the shaft? Any advise appreciated.
352
« on: July 26, 2018, 08:16:41 PM »
BTW it does work, I used it to fix mine.
354
« on: July 05, 2018, 04:49:21 PM »
The 750 was H reg, engine number 1004***. Never got to see the owner of either of them.
355
« on: July 05, 2018, 12:24:59 PM »
Leigh Arms last night. (A49 just outside Northwich)
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
Something to cast your eyes over.
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
356
« on: May 29, 2018, 03:55:16 PM »
Hi All,
Trying to find a grease gun that will fit the 400 swing arm nipple. Can anyone let me where I can get one from? Thanks.
357
« on: May 27, 2018, 09:49:09 PM »
Used the hacksaw method on mine, two cuts. There is advice on here but I can't remember who posted it. With two close cuts removing a thin strip the rest came out easy.
358
« on: May 27, 2018, 09:15:42 PM »
Thanks Julie, reliable as ever. 
359
« on: May 27, 2018, 09:08:31 PM »
Hi All,
Can anyone advise on the original finish of the CB400 wheel hubs?
TIA.
360
« on: May 17, 2018, 10:23:22 PM »
Coincidence or what!!! Let me know how you get on.
Pages: 1 ... 22 23 [24] 25 26 ... 31
|
Show Posts