This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Deano400
Pages: 1 ... 23 24 [25] 26 27 ... 31
361
« on: May 17, 2018, 10:00:02 PM »
362
« on: May 17, 2018, 09:04:52 PM »
Do you mean this seal? AE1967E
The parts book only shows the complete unit and not the seal as a separate item.
363
« on: May 17, 2018, 03:31:34 PM »
Spindle and plug out today.  Put the speedo drive in the freezer for a couple of hours then applied a bit of heat to the casing then tapped out the spindle with my newly acquired spindle removal tool!! Came out quite easy, only a few light taps.
364
« on: May 16, 2018, 09:12:57 PM »
Circlip is out, gear wheel is out, little screw is out, but I can't get the spindle / plug out, any ideas?
365
« on: May 16, 2018, 01:55:00 PM »
Yes can see the circlip now I've removed a load of crud.
366
« on: May 16, 2018, 12:59:52 PM »
Thanks Hairy much appreciated.
367
« on: May 16, 2018, 12:22:58 PM »
I'm looking for some advice on my speedo drive. I would like to strip and clean up. Has anyone got any tips on getting it apart? Little screw comes out easily enough but where do I go from there without butchering it?
By little screw I don't mean the one in the picture, it's a very small one out of view.
368
« on: May 15, 2018, 10:00:38 PM »
Great thread Julie. I use it quite often for reference and probably will do through out my build. Thanks.
369
« on: May 14, 2018, 10:20:52 PM »
Very interesting read everyone. You learn something new every day on here.
370
« on: May 12, 2018, 03:52:53 PM »
Thanks Julie / Hairy,
I was looking at getting bronze off Frank, but he's just messaged me saying he hasn't got any. I do have some plastic ones and was wondering if it was worth fitting them as they are more likely to wear rather than the pivot which are few and far between.
371
« on: May 12, 2018, 03:41:23 PM »
372
« on: May 12, 2018, 03:36:53 PM »
Thanks Julie,
21.42 one side, 21.43 the other.
373
« on: May 12, 2018, 02:15:37 PM »
Hi,
The swing arm collar seems 'loose' in the bushes. Not sure whether it's worn over the years.
Does anyone know the spec / tolerances for the collar?
374
« on: May 11, 2018, 09:42:20 PM »
375
« on: May 09, 2018, 09:55:27 PM »
Had a bit of damage to the barrel and head fins (PO not me!!).
Before:
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
After:
[ Guests cannot view attachments ]
I'm impressed. All credits to CB Classic Motorcycles.
Pages: 1 ... 23 24 [25] 26 27 ... 31
|
Show Posts
