This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Norniron
Pages: 1 ... 5 6 [7] 8 9 ... 28
91
« on: July 26, 2015, 08:40:03 PM »
In the profession we use vacuumate, not cheap and not for home use  Unless your name is Norniron
My home address is also my work address Trigger😉😉😉😉😉
92
« on: July 13, 2015, 11:55:15 PM »
It depends on whether your 550 is an F or a K.
The kickstarts are different on each model.
93
« on: June 22, 2015, 09:50:36 PM »
Anything is possible with electronics and coils can fire happily outside but fail under compression, how can it possibly be OK to run a 9volt coil at 12volts continuously!
Had that the other day on a Triumph, lovely spark but, no spark under compression.
A triumph! Never trig
94
« on: June 07, 2015, 10:26:23 PM »
My F2 rear
95
« on: May 17, 2015, 01:13:45 AM »
Looks like this guy on ebay found one!
96
« on: May 16, 2015, 11:40:35 AM »
Wheres the carbs?
like any V, between the cylinders 
Micro carbs then
97
« on: May 16, 2015, 11:37:09 AM »
Wheres the carbs?
98
« on: May 11, 2015, 10:51:57 PM »
Thats good to know they inspect some of their parts
pete
True pete
99
« on: May 11, 2015, 10:48:53 PM »
if u use the standard 400 wheel i think there may be an issue with fitting an extra disc plus the speedo drive.i assume u are gonna use the 400n fork legs too.
I swapped the whole front end from a k3 550.
100
« on: May 11, 2015, 10:32:51 PM »
Yep,i think the 400n is a straight swap,or u could choose the 550 front end which is a bit more work.
With the 400 n u may have to use the comstar wheels though!
101
« on: April 20, 2015, 10:49:42 PM »
Well i bought one of these,got it today,getting sent back tomorrow.
Doesnt f*****g work.you think dss would test them before sending them out.
Wots the chances of me getting all my p+p charges reimbursed?
102
« on: April 11, 2015, 12:53:32 PM »
Can u post some pics stuart.
Trigger mentioned the pivot arm,is it inline with the disc before fitting the pads?
103
« on: April 11, 2015, 12:47:29 PM »
No trigger not yet
104
« on: April 10, 2015, 08:23:11 PM »
No i didnt do anything with the idle jet but i suspect i ought to.
I just turned up the idle speed to about 1600rpm.
105
« on: April 09, 2015, 09:30:55 PM »
I have spare size 75 jets if u want to rebore them with your bits.
Pages: 1 ... 5 6 [7] 8 9 ... 28
|
Show Posts