This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - martyn1061
Pages: [1]
1
« on: April 13, 2022, 11:18:04 AM »
Thanks for the tip.
2
« on: April 13, 2022, 08:14:13 AM »
Thanks. I will try to set the tickover with throttle cables disconnected, i have not balanced them yet as it has been difficult to get it to tick over at a steady 1200 rpm. Yeah new rings on manifold mounts.
3
« on: April 12, 2022, 06:25:02 PM »
The jets came from david silver and quoted as original and your right they are a lot more expensive
4
« on: April 12, 2022, 06:14:35 PM »
Hi
They are new mounts and seals so they should be ok.
5
« on: April 12, 2022, 06:03:33 PM »
Hi guys
My carbs have been recently ultra sound cleaned and rebuilt with new original jets, but when running sometimes it will rev at about 3000 revs and then won't tick over at all. I'm at a loss, if anyone got any idea what the cause will be great.
6
« on: December 15, 2021, 04:50:18 PM »
Hi
As i have got the carbs back out i will put the original jets back in and recheck float heights
7
« on: December 15, 2021, 03:26:11 PM »
I'm running single filters, compression good, all new jets etc. I have removed the carbs again now so i will re check float levels.
8
« on: December 15, 2021, 11:13:34 AM »
Hi Gareth
Thanks for that, i have done that, I have even adjusted the air screws out 2.5 turns to weaken it further but still running rich.
Unless I re-strip the carbs and recheck float heights.
Martyn
9
« on: December 15, 2021, 10:42:47 AM »
Hi
Just overhauled carbs, started up and motorcycle running very rich. Any ideas how to adjust mixture strength.
Thanks
10
« on: November 08, 2021, 03:41:19 PM »
Thanks for the info, I'll contact him
11
« on: November 08, 2021, 01:24:11 PM »
Thanks
They look good, just got trouble contacting them reference getting mine re-conditioned
12
« on: November 08, 2021, 01:04:25 PM »
Hi
Has anyone used CB750faces.com for gauge restoration or know if they are still in business, as i am having difficulty in contacting them.
Thanks
Pages: [1]
|
Show Posts