SOHC.co.uk Forums > CB500/550
Perhaps if this guy sells a few of these he might afford a decent camera
Green1:
Graham I hope you had the rubber analyzed and made to the exact spec ;D
AshimotoK0:
--- Quote from: Jamesh_sussex on May 01, 2016, 10:12:45 AM ---Does anyone have a set of NOS HM300 pipes they can sell me? I'm only prepared to pay £125 plus post...
Seriously, a lot of time and effort had gone into producing what is an obsolete part. £17.50 is a bargain.
--- End quote ---
How many sets do you want James? Chris in Japan says he can get you as many as you want for that price.
They are for this Model: ;D
http://www.ebay.com/itm/1-6-scale-Honda-Dream-CB750-FOUR-Plastic-Model-Kit-Japan-BIKE-/131209313609
Johnwebley:
hi Trigger,
as a user of one of your excellent steel clutch pushrod,(CB500) ,I had to remove the drive cover the other day,and found
the push rod seemed to magnetic !! the little ball bearing was on its end,instead of deep in the actuation mech,
on assembly I greased the hole and pushed the ball back,
if it happens again,just a warning as it would be a pain to loose the steel ball,
Trigger:
--- Quote from: Johnwebley on May 02, 2016, 12:12:18 PM ---hi Trigger,
as a user of one of your excellent steel clutch pushrod,(CB500) ,I had to remove the drive cover the other day,and found
the push rod seemed to magnetic !! the little ball bearing was on its end,instead of deep in the actuation mech,
on assembly I greased the hole and pushed the ball back,
if it happens again,just a warning as it would be a pain to loose the steel ball,
--- End quote ---
Cheers for the feedback John. I tested the rod over 3,000 miles and had no problems. Not sure how the silver steel rod has become magnetised but, if you lose the ball I will send you another FOC.
Johnwebley:
--- Quote from: Trigger on May 02, 2016, 12:40:55 PM ---
--- Quote from: Johnwebley on May 02, 2016, 12:12:18 PM ---hi Trigger,
as a user of one of your excellent steel clutch pushrod,(CB500) ,I had to remove the drive cover the other day,and found
the push rod seemed to magnetic !! the little ball bearing was on its end,instead of deep in the actuation mech,
on assembly I greased the hole and pushed the ball back,
if it happens again,just a warning as it would be a pain to loose the steel ball,
--- End quote ---
Cheers for the feedback John. I tested the rod over 3,000 miles and had no problems. Not sure how the silver steel rod has become magnetised but, if you lose the ball I will send you another FOC.
--- End quote ---
if I got a spare,I would have a fine shiny pair !!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version