SOHC.co.uk Forums > CB500/550

1st Article on 500/4 in MCM

(1/5) > >>

AshimotoK0:
Enjoy! (Also found the one with the Honda training School 500/4 engine strip).

[ Guests cannot view attachments ] [ Guests cannot view attachments ] [ Guests cannot view attachments ]

AshimotoK0:
[ Guests cannot view attachments ] [ Guests cannot view attachments ] [ Guests cannot view attachments ]

GiannisFour:
Thanks mate!!! :)

Seabeowner:
I sorted out my old mags a while ago and I also have both of these and was reading through the rebuild this afternoon!
With horror I came to the picture of the clutch on P44 and read the line about the orientation of the top clutch plate. It is also in bold in the shop manual. I've just bolted up my 550F engine. I have no manual for the 550.

But I did have tucked away a clutch assy from a 550K1 and one from for a K3. Both do not seem to have the swept grooves in the top friction plate. Presume that the idea was dropped as a waste of money and 550s all have straight cut grooves.
Phil

RGP750:
Thanks Ash
One of the mag's that got me to buy mine in 1973.
Still rate it as my best bike.

Navigation

[0] Message Index

[#] Next page