SOHC.co.uk Forums > CB750
Cb750 f2 k4 engine bolts and ideas
K2-K6:
The K7 is paired with the F2 so may offer best options if any differences are there.
CR750 maybe able to shed some more light on that route.
onethumb:
Thats the information I was looking for.
That's well worth knowing. I'll start the search. Thanks.
Sent from my iPad using Tapatalk
MarkCR750:
I bought a stainless bolt set on ebay, the only one that was too long was the one that goes through the foot pegs (because there are no foot pegs in that position now), I used a spacer to take up the slack on that one but will get it cut down and thread recut at some point, I can only see this one for the 550 at the moment but you could email them to ask.
http://www.ebay.co.uk/itm/MOTORCYCLE-STAINLESS-STEEL-HONDA-CB550-FOUR-SOHC-ENGINE-MOUNTS-BOLT-KIT-/361582221866?hash=item542ffada2a:g:288AAOSwiYFXD1si
onethumb:
Hi markCR750, thank you. I've sent an email so hopefully I'll get a bit more info.
Thanks again.
Steve.
Sent from my iPad using Tapatalk
yozzer74:
This is mine after .I had both ends cut off and threaded then two titanium flanges nuts on each end .and 2 stainless steel caps turned up on ends . [ Guests cannot view attachments ]
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version