SOHC.co.uk Forums > CB350/400

400/4 wont rev past 4000rpm when under load

<< < (2/3) > >>

gtmdriver:
Don't forget that when you adjust the idle screws you are only changing the mixture at idle and perhaps just a little above that. The idle screw certainly won't be affecting the mixture at 4000 revs and above.

Spitfire:
I don't know where this came from but it does show the relationship between the various carb jets/parts and throttle openings.



Cheers

Dennis

Rirons:
Bike it now running well, and although part of the reason for rough running is a little embarrassing  I thought I'd share it anyways.

Firstly I cocked up the valve timing so that didn't help, got away with it i.e. pistons and valves didn't clash, the float heights were miles out as i did them the haynes manual way. I had a noise which sounded like tappets but turned out to be the head gasket protruding into the cam chain tunnel, pushing the chain across and running hard against the cam sprocket, causing it to grab, now i though I'd put the gasket on the wrong way but the Ive checked and turning it over gives the same issues, it just a badly cut gasket, and its gen Honda, plus the cam chain was tensioned incorrectly. Now all is sorted and running well revs freely, also set the timing using strobe, so its spot on, now  has power with very little tappets/cam chain noise.

Thanks to all who pointed me in the right direction. Now its all about riding in this lovely English summer :(

mike the bike:
Glad you've got it sorted.  There's nothing worse than a bike that's temperamental.   Anyone want a 650 Katana that needs a bit of fettling?   It's going on fleabay soon, I've had enough of it.

Laverda Dave:
I have set my carb floats using the Haynes method although I haven't yet started the bike. Is there another secret method I should be using?
Dave

Navigation

[0] Message Index

[#] Next page

[*] Previous page