SOHC.co.uk Forums > CB750
throttle not returning
Chris400F:
Does the inner of the return cable move freely, particularly when the cable is in place?
Can't see what angle it is coming out of the twistgrip from the photo as the cables are underneath.
El__burro:
Here are some pictures of the extremity of the cables.
When I unhook the lower (return) cable from the carb link it does fine.
el__burro
hairygit:
Looks like the opening cable is over tight, where the cable attaches to the carbs there should be a locknut either side of the bracket, in the picture you have both at the end of the cable bracket, try it with one nut either side.
tom400f:
Might be too obvious but both of the cables look stressed where the flexible leaves the twist grip, they take an unnatural downward turn. Perhaps route them above that brake union? Not sure what the correct routing should be and how customised your bike is.
K2-K6:
A question, has it always done this, difficult to turn, since you had it going? Or has it changed?
When you disconnect the carb end of the return cable it will still be moving that cable but the action is ok. So it's not coming from the internal cable being stiff.
With both cables connected, is there any rotational slack at the twist grip at all and if so how much?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version