SOHC.co.uk Forums > CB750

throttle not returning

<< < (2/5) > >>

El__burro:
The throttle comes from a VTR1000F and it fits nicely.
I am not sure about the routing.. (check the img attached).

Thanks
el__burro

neat street:
Also check the routing from the carbs, should go over the fuel tank brackets I believe? I had the same issue with mine when steering turned right. re-routed cable over the top of the fuel tank bracket, and all fine.

El__burro:
Removed the tank and disconnected the return cable (bottom one).
It works fine.
Then I need to reattach the cable again and the problem is back.
any ideas?

el__burro

K2-K6:
I don't know what adjustment you've got on your cables,  the standard ones usually have no adjustment for the return cable so no options there.

The pull cable has more scope so put all the slack you can get in that one and it should get rid of the conflict between the two. I know it sounds kinda back to front but it's how they are set up, you can then adjust the pull one a little if you need to but if you do, then check as you are doing it by turning the steering from full left to full right while twisting and releasing the throttle to make sure it doesn't bind again.

The Honda manual stipulates just how much slack the twist grip should have in it to avoid the cables binding but people tend to adjust them tight and think the throttle will somehow open further.

Greebo:

--- Quote from: El__burro on July 18, 2016, 08:33:49 PM ---Removed the tank and disconnected the return cable (bottom one).
It works fine.
Then I need to reattach the cable again and the problem is back.
any ideas?

el__burro

--- End quote ---

When you put the tank back on sounds like you maybe trapping/bending the cables in an awkward position

Navigation

[0] Message Index

[#] Next page

[*] Previous page