SOHC.co.uk Forums > CB350/400
Goodridge hose fitting
Spitfire:
I bought the braided hose lines from a firm called CMS on eBay, this was in 2007, I just specified what I wanted as below, I also sent him my old brake lines for reference.
"As discussed could you please make up a new top hose (MC to 3-way splitter) and make up a single new bottom hose to replace the standard bottom hose and pipe section (3-way splitter to brake calliper). To maintain the bikes standard appearance the lines should be black sheathed"
The grommet on the HEL lines does not really fit anything though and is not strictly necessary.
Cheers
Dennis
stevush:
The bike is not ready for the road yet and still very much a work in progress so the mudguard has not been fitted yet. In the picture I have used a tie wrap on the fork leg just to keep the hose away from the wheel temporarily. Even with the mudguard fitted the angle from the caliper wouldn't change. Its clear from the Spitfire picture that the hose is angled backwards immediately from the caliper towards the forks rather than my setup which sends it towards the wheel, this is what I'll be hoping to do. Maybe the second picture shows it better.
Steve
gtmdriver:
I had a special made up just like the one posted by Spitfire.
stevush:
Thanks GTM. Who made up yours ?
Steve
stevush:
Thanks Oddjob, I'm pretty sure what I need now, I'll wait to see what the supplier comes back with then I'm hoping someone can make up or supply a hose with an elbow to take it towards the forks and away from the whell
Steve
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version