SOHC.co.uk Forums > Project Board
CB750 Barn find project - First Timer
Underdog1:
As I'm now home for a couple of weeks for xmas I stuffed the anchor in the boot of my car and took it into my family home where I can utilise the garage rather than ruining the carpet in my house ;D
Took everything off in preparation to split the cases, had to leave the clutch and rotor on as i don't currently have the correct tools.
I had to take the engine off the stand after removing all the upper case fixings to split the cases so just chucked onto a workmate type bench, was a little worried about how precarious it was going to be but its weighted enough at the rear to balance nicely.
Removed all the lower case fixings and tapped around the edges with a block of wood and hammer and without too much trouble cracked the old girl open.
Happy that this was relatively pain free and will have time to dive into it deeper tomorrow.
A few quick questions though -
I need the engine fully stripped down for cleaning and painting, will the rotor now come out with the crankshaft in one piece and will the clutch come out with the transmission main shaft? or do i still need the special tools to get them out?
For the gear shift mechanism i only removed the shift arm and counter shaft bearing holder, couldn't get the other bits off as i think the screw holding the gear shift side plate is staked in place?
hairygit:
The crank will lift out with the rotor attached, as will the clutch and gearshaft. There is no need to dismantle the pins and endplate on the selector drum at any point unless there was a gear selection problem before you stripped it.
Underdog1:
--- Quote from: hairygit on December 18, 2016, 05:01:48 PM ---The crank will lift out with the rotor attached, as will the clutch and gearshaft. There is no need to dismantle the pins and endplate on the selector drum at any point unless there was a gear selection problem before you stripped it.
--- End quote ---
That's good news then, will take it to bits tomorrow then. I never actually rode it before I stripped it as it was sold as a non runner, carbs were all gunked up so I cleaned those up and got her running before tearing her apart but the drive chain was rusted so didn't want to actually try riding it first! I'm hoping the reason it was layed up was just the carbs and so far it doesn't look like it's had much of a hard life at all.
Underdog1:
Final question of the day guys..
Would putting the engine casings/head/barrels etc through a dish washer with regular dish washer tablets damage either the parts or the dish washer itself? Considering doing it tomorrow secretly ;D
hairygit:
Really can't answer that one, my dishwasher would notice and complain bitterly! ;D Although Ashimoto may know, he will try almost anything once!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version