SOHC.co.uk Forums > Project Board

CB750 Barn find project - First Timer

<< < (50/119) > >>

Bryanj:
Tat O ring should be 18 x 3

Underdog1:

--- Quote from: Bryanj on February 20, 2017, 06:20:51 AM ---Tat O ring should be 18 x 3

--- End quote ---

Yeah seen, turns out I had been sent a 19x3 by accident

Niko:
Check out a motogadget m unit to simplify wiring as an option


Sent from my iPad using Tapatalk

Underdog1:
More progress today, closed the cases -



And then built up the legal linkage and alternator bits.

BUT

For some reason I've had an absolute nightmare with the clutch cover..

I just can't get the bloody thing on! The dowels are in the crankcase and I can get the right side of the cover lined up but the left side is always too high, it's like the kickstarter shaft is pushing it up too far.





If I've some how mis aligned it whilst assembling and have to split the cases again I'm not going to be best pleased! Suggestions welcome  ;D

Trigger:
Your kick start shaft is too close to the clutch basket. Put the clutch cover on, then the kick start lever, turn the engine with the lever while pulling it back and locate the cover up. If that doesn't work, report back.

Navigation

[0] Message Index

[#] Next page

[*] Previous page