SOHC.co.uk Forums > Project Board
CB750 Barn find project - First Timer
Seabeowner:
--- Quote from: SteveD CB500F on June 09, 2018, 08:46:05 AM ---Where’s Ash when we need him?
Sent from my iPhone using Tapatalk
--- End quote ---
It's a shame he's not active, certainly missing him. Hope he's fine.
sye:
It would seem that Muriatic Acid is hydrochloric acid over here and it's most common use is as a brick cleaner:
https://www.toolstation.com/shop/p29118?r=googleshopping&rr=marin&utm_source=googleshopping&utm_medium=feed&utm_campaign=googleshoppingfeed&gclid=EAIaIQobChMIg6vyl6bG2wIVaLXtCh0FlwSnEAQYASABEgJjEPD_BwE
It can also be obtained rather cheaply from chemical suppliers:
http://darrantchemicals.co.uk/muriatic-acid
71 V12:
I don’t know where you are in the U.K. but this company cleaned my tank recently. I would say it was worse than yours. Like brand new inside now. They charge about £40 and turn around in 48hours.
Voith Industial Services
Warwick House, Watling Street
Wilnecote
Tamworth Staffordshire B77 5BH
United Kingdom
Just off the M42 jnc 9.
Cheers
Kevin
Underdog1:
Engine back in, but turns out we’ve got a bit of a houseful today so not got much further.
Seems the powder coater missed taping the thread for the grease nipple on the swing arm. Tried cleaning it out best as I can and screwing it in but I think the grease nipple has started to cross thread
What size thread is it? 6mmx1mm pitch? I’ve got a tap I can run down it but wanted to check first as I don’t want to wreck the thread in the swingarm if I can avoid it - is this a known weak spot?
Bryanj:
Not normaly weak, that has to be a later swing arm if it only has one nipple underneath
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version