SOHC.co.uk Forums > Project Board
CB750 Barn find project - First Timer
Trigger:
The horn needs to go to ground , the earth lead and the coils ;) If you have drilled the bars, be careful that they don't snap :o
Underdog1:
--- Quote from: Trigger on July 08, 2018, 07:35:35 PM ---The horn needs to go to ground , the earth lead and the coils ;) If you have drilled the bars, be careful that they don't snap :o
--- End quote ---
I think the ground for the horn is in the actual switchgear itself and grounds to the bars? Would make sense as the horn could be weak from having to ground through a layer of powder coat.
They are steel bars so should be good to go with a few little holes
Trigger:
Nope, the ground to the horn is PN 38105 323 000 ;) Or 38120 392 620
Underdog1:
--- Quote from: Trigger on July 08, 2018, 08:10:30 PM ---Nope, the ground to the horn is PN 38105 323 000 ;) Or 38120 392 620
--- End quote ---
Yeah I’ve got that, just connects the horn to the harness by the coils, so all good there. Next step is to get some batteries in my multimeter and start poking around. Wish I’d just spend the extra few ££ and got a K6 harness rather than shoehorning an earlier one in
Underdog1:
I think I’m going to repair the old harness and try that, conditions not too bad, couple of connectors need cleaning up and the connection to the battery +ve is a little fried.
What else can I do outside of a spray with contact cleaner to try and improve the state of all the bullet connectors?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version