SOHC.co.uk Forums > Project Board
CB750 Barn find project - First Timer
Underdog1:
--- Quote from: Rob62 on July 22, 2018, 09:23:44 PM ---Any baffles in there ? :D
Looks nice, is it a good fit onto the cyl head? The headers and collector look nicely formed, what make is it, or is it made up from various pipes?
--- End quote ---
It has a stainless steel perforated core but it’s pretty open.
Headers are from MAC and end can is From Cone Engineering, both were
Picked up when I was overseas and had 20kg baggage allowance!
Underdog1:
Been thinking about the breather hose that comes from the back of the cylinder head thismorning, originally it connected to the air box but now that’s gone I need another solution.
I could just route it down to the ground so anything coming out of it would go overboard - but on a well running bike should anything be coming out of it outside of vapour? You can get fancy little filters to go on the end of the breathe hose which you can attach anywhere but in my head I’m imagining it becoming sodden with oil over time and causing a mess?
Bryanj:
There should only be vapour coming out, unless you have a problem. The 500 does just exit to atmosphere just in front of the rear wheel
Underdog1:
--- Quote from: Bryanj on July 23, 2018, 10:51:19 AM ---There should only be vapour coming out, unless you have a problem. The 500 does just exit to atmosphere just in front of the rear wheel
--- End quote ---
Nice one bud.
Anyone know where I can get a shorter speedo cable from? I’m not using the front fender (will use a brace) so It’s now got a lot of slack where it loops backwards, ideally I’ll just run it up the inside of the fork lower instead so could do with it being 20-30cm shorter
Bryanj:
Dont know anybody who makes custom speedo cables, used to find longer ones in the US for the chopper boys but never seen shorter. Perhaps a different Honda bike might fit?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version