SOHC.co.uk Forums > Project Board
CB750 Barn find project - First Timer
Underdog1:
--- Quote from: Nurse Julie on August 10, 2018, 09:35:21 PM ---I bet Hondaman was responsible for the gaskets being flubbered, I think he says use gasket sealer.........😭😭😭
--- End quote ---
Exactly that!
Rob62:
Bit of bad luck there Ud.... hopefully you can get it repaired. I have a mate who is a wizard at aluminium weld repairs but he is in Hull :( ... But those type of repairs are def possible. Try to seek out somebody who specialises in that type of thing.. Good luck !
Trigger:
I would be welding that damage. Once the spring is under the correct tension it may break the rest of the case.
While the engine is out i would be investigating why the oil is not getting to the top end. It only takes a little sliver of Honda bond to block the oil ways and the jets. Check that you have all the correct 0'rings in place, as one missing or wrong size 0'ring will effect the oil pressure ;)
Green1:
Never understood using sealant on gaskets. Why use a gasket if your going to use sealant? ???
I always grease them even though it feels wrong its so right.
Nurse Julie:
Almost every Honda engine we get sent from USA for overhaul needs major welding. Usually where the chain has made a massive hole in the cases, all need fin repairs and general casing repairs but Trig does it himself.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version