SOHC.co.uk Forums > CB350/400

gear box

<< < (3/4) > >>

AshimotoK0:
Russ told me it's the 13.7mm one on the 400/4. The bush when I pressed it out had similar markings to SOHC crank shells on the OD probably made by the same company.
In the post today Russ

Cookie2050:
Cheers ash

Working nights this week so i should be able to get on with it.

Greg65:
Ok, have the same problem. So can anyone tell me the dimensions of the bush required so I can try and source a replacement.

Thanks,
Greg

Greg65:
Had a session with the micrometer and the shaft measures up at a fraction under 20mm and using a digital calliper I think the outside diameter of the bush will be 23mm but this is a bit of an estimate, can anyone give me a more precise figure?

Greg

ttr400:
I make these bushes all the time for that gear, but i match the new bush to the gear and shaft. I use Bronze.

Best is to take the gear and shaft to a local machine shop, they will turn one up in no time.

Kevin

Navigation

[0] Message Index

[#] Next page

[*] Previous page