SOHC.co.uk Forums > CB750

CB750 Oil Control Orifice (early diecast K0).

(1/3) > >>

JamesH:
Hi guys. I'm on the hunt for some unicorn shit...

Need a pair of oil control orifices / jets for an early 750K0 head. Anyone know of anyone who has there or (long shot) even reproduces these?

Pics below...

RGP750:
If You want to risk sending me the two types i'll do some fishing
about having some made.

JamesH:
Sorry Rich, should have been clearer, it's one type, just photographed from both sides..I'll see if Graham doesn't mind popping the one we have in the post to you...

AshimotoK0:
I think you will need to get the holes cut with a micro laser. I get tiny, perfectly circular holes cut in three sizes in the  s/steel foils used on a scanning electron microscope unit we make. One hole is so small you can't see it with the naked eye. I get them made via my mate in Cambridge ... I can get you the details if you wish Rich ..pretty sure someone on the USA forum was planning to have those made too. Must be later K0 ...mine just has a hole ...no removable jet whatsoever. Obviously, this had been debated before on here.

You could also sell that part to fit onto the spout of a dollies watering can  ;D ;D


update see here:

http://forums.sohc4.net/index.php?topic=154725.0

Phil k:
Is that a 12238-300-300? I have one that I purchased in error a couple of years back. If you still need it.

Phil


Sent from my iPad using Tapatalk

Navigation

[0] Message Index

[#] Next page