SOHC.co.uk Forums > CB350/400

Wiring loom routes

(1/1)

postman:
Hello,
could somebody confirm the routing of the loom on my 400/4? Does the main loom pass above or below the bottom yolk? Also where is the handlebar switch connector positioned. When I bought the bike it was hanging down between the exhausts but that does not look right. Finally I have seen a picture of the loom running above the coils whereby mine runs below.
I would be most grateful if somebody could confirm and maybe post a couple of pictures?
Thanks in anticipation.
Pat.

Chris400F:
Check out page 110 of the CB350F/400F Shop Manual in Ashimoto's Dropbox (http://www.sohc.co.uk/index.php/topic,8884.0.html).
I think the diagrams there should show exactly what you want.

postman:
That's brilliant. Thanks.

AshimotoK0:
Bit of info on P14 onwards in this in my Dropbox too

CB400F DEALER SETUP INSTRUCTIONS .. RARE !!

http://www.honda4fun.com/pdf_man_officina/CB400_set-up_man/CB400_set-up_man.pdf

Navigation

[0] Message Index