SOHC.co.uk Forums > CB350/400
Anyone used this company?
Nurse Julie:
--- Quote from: AshimotoK0 on November 17, 2016, 01:03:16 PM ---
--- Quote from: Nurse Julie on November 17, 2016, 12:44:12 PM ---I have always found their carb kits fine and have used quite a few, including on my CB400/4. But, as Rich says, other forum members may, no will, tell you different.
--- End quote ---
Give a dog a bad name Julie :-[ :-[
--- End quote ---
I was only pointing out that other forum members, (and I will not mention any names) seem to have a genuine dislike of their rubber bits and that those forum members will pipe up sometime with their own opinion. And, your no dog Ash ;D ;D ;D
Tomb:
I bought one of their 4 cylinder big bore kits for a Yamaha which was really good quality, all measured up beautifully, very impressed.
Tom (Toolmaker)
andeks:
Thanks for the replies, seems like it's " suck it and see" if you'll excuse the expression. Looking at their timing chain next !!
philgresty:
I rebuilt my 550 carbs with their kit, the jets and needle were spot on, the float valves werent very good and neither were any of the rubber parts. I wouldn't hesitate to buy pistons though, heard nothing but good things about them.
ManicGTI:
I've used their Rings and Carb Rebuild kit, but i'm not a great reference as the bike isn't on the road yet!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version