SOHC.co.uk Forums > CB750

CB750 front fork pipe question

(1/2) > >>

Sgt.Pinback:
I can buy a set of NOS CB750 F2 front fork pipes (51410-393-003).

Will they fit into early KO (sandcast) and/or will I have to change more of the hardware to do so?

Thanks

adriangsmith:
Not sure about the pipes but the bottoms were different on the F2

AshimotoK0:
I very much doubt it Uli. Best place for K0 ones  is Yamiya, made in Japan. DS ones are made Italy and it's reported that they are chromed in areas they shouldn't be and don't fit without additional maching.

philward:
I think that the f2 tubes are 906 mm long from memory - earlier tubes are shorter (less than 900mm). Only know because there are lots of repo's on ebay and they state they state they don't fit earlier models

Green1:
Sandcast and K1 tubes have a smaller diameter than other models

Navigation

[0] Message Index

[#] Next page