SOHC.co.uk Forums > CB750

Honda CB750K2 - K6 Engine Mount Brackets - Desperately Seeking

<< < (2/3) > >>

MCTID:
Just seen this Phil......if you want to pop over to Lytham St Annes you can borrow mine to use as templates. My K4 is (still) in bits..........I could take some dimensions and photos for you but it's probably better if you just took the plates and made some up.

I'm not in any rush to get mine back as long as its weeks rather than months.

Please PM me for more details.

philward:
There the ones Graham - if you can't easily sort a template, I'll take up MCTID (sorry, i don't know your name) up on his offer and try to get up there over the next few weeks.
MCTID - If Graham can't sort a templates, I'll PM you over the next few weeks - your about 45 miles away - as I am away over Christmas
Thanks to both - much appreciated.
Phil

Trigger:

--- Quote from: philward on December 20, 2016, 02:51:16 PM ---There the ones Graham - if you can't easily sort a template, I'll take up MCTID (sorry, i don't know your name) up on his offer and try to get up there over the next few weeks.
MCTID - If Graham can't sort a templates, I'll PM you over the next few weeks - your about 45 miles away - as I am away over Christmas
Thanks to both - much appreciated.
Phil

--- End quote ---

I can draw round them is two minutes, quicker than driving 45 miles  ;D
PM me you address Phil if you like me to do some drawing.

philward:
I've PM'ed you Graham - thanks

MCTID - Thanks also for your offer

Thanks
Phil

Trigger:
All drawn up Phil, will pop it in the post to you. You will require 4mm plate to make these up.

Navigation

[0] Message Index

[#] Next page

[*] Previous page