SOHC.co.uk Forums > CB750

K(0) - K6 Cylinder Head Exhaust Collers/manifolds Screw Removal

<< < (2/2)

philward:
Well its defeated me so far!  blow torch heat, hammer blows and 2 broken impact bits and not one has moved a jot! Have sent for the bits recommended on an earlier thread - havn't touched the knackered screw yet as if the others don't shift, I'll buy an exhaust that uses the stubs/manifolds and leave them in!
I'm at the stage on this project where I feel I'm not making much progress - lots of research, mods and waiting to save for expensive special parts - hopefully it will be worth it though.
Problems like this just seem bigger when you're at a low on a build
Thanks for all the info and help

Trigger:
When I mean heat Phil, you need it to be glowing red.

philward:
I've only got a gas bottle Graham - what I use for soldering! Will wait for the new bits and have another go. Otherwise it's back to my BAE airframe fitting days drills and tapping! We weren't allowed to hammer and heat things - we couldn't even use a centre punch!

Sent from my MotoG3 using Tapatalk

Trigger:

--- Quote from: philward on December 28, 2016, 08:32:59 PM ---I've only got a gas bottle Graham - what I use for soldering! Will wait for the new bits and have another go. Otherwise it's back to my BAE airframe fitting days drills and tapping! We weren't allowed to hammer and heat things - we couldn't even use a centre punch!

Sent from my MotoG3 using Tapatalk

--- End quote ---

If someone has put retainer on the thread, your need something to get it red hot.

Navigation

[0] Message Index

[*] Previous page