SOHC.co.uk Forums > CB750

CB750 Cams - Advise

<< < (2/3) > >>

Trigger:
The cam on the right looks like the same type of lobes you would find on a DP315, are you sure it doesn't have this number stamped on it Phil.

philward:
Will check tonight Graham, but its knackered anyway on one lobe - it looks like due to lack of oil
What is a DP315?

Laverda Dave:
Phil, if you wish to use the damaged cam it might be worth your while contacting Mike Newman at Newman Cams?  They might be able to regrind or metal spray it for you as they were going to do for my CB250RS cam.
Dave

philward:

--- Quote from: Laverda120 on January 31, 2017, 12:36:20 PM ---Phil, if you wish to use the damaged cam it might be worth your while contacting Mike Newman at Newman Cams?  They might be able to regrind or metal spray it for you as they were going to do for my CB250RS cam.
Dave

--- End quote ---
Thanks Dave - I will be using the other cam now I know its a standard K6 but depending on what Trig says its from, I may use it on my next build
Phil

philward:
Graham - marks on that cam are D1 & CWC stamped marks and just spotted NORRIS R 'etched' on a flat on shaft between 1 & 2 . Looks like a performance cam - bought an engine off DK a few years ago that had high compression 836 kit and triple valve springs in (I remember getting advice from you on them) probably from that engine

Sent from my MotoG3 using Tapatalk

Navigation

[0] Message Index

[#] Next page

[*] Previous page