SOHC.co.uk Forums > CB350/400

Dresda Swinging Arm Anyone ?

(1/2) > >>

andut:
Morning all,

Has anyone got a 400/4 with a Dresda arm ?  My latest project came in various boxes and has a Dresda arm, but I can't find the rear axle spacers, so wondering if anyone has similar and wouldn't mind a quick measure of the spacers either side please ? 

Any help greatfuly received !

Andy

Bryanj:
From aged memory you use the standard  Honda ones

andut:
The Dresda's box section is quite a bit wider that the chain adjusters in the standard set up, so i run out of axle to get a nut and split pin in place with the standard spacers from my other bike.  Just wondering if anyone can confirm length of the std spacers or if anyone has a Dresda fitted ?

Andy

andut:
Mystery solved and an update having found a spacer in my box of bits and playing with a steel rule - just in case anyone needs similar info in future ........

The Dresda arm's open end outer face to outer face is ~255mm which is the same as a std swinging arm with adjusters fitted.  The Dresda arm's box section is however ~25mm wide vs. ~18mm for the standard arm with adjusters, leaving an inner face to inner face distance 14mm narrower for the Dresda.  I found a 19mm spacer in the various bits and pieces which is conveniently 14mm shorter than the std 33mm spacer normally fitted to allow for the reduction - problem solved !

Chris400F:
Andy,
Forgive me if I have missed something (it wouldn't be the first time!) but surely you need to have a smaller spacer each side to keep the gearbox / rear wheel sprocket alignment correct, unless there is some sort of offset with the Dresda swinging arm.

Navigation

[0] Message Index

[#] Next page