SOHC.co.uk Forums > Recommended Sources for Parts and Services

Cheapo Rotor Puller ...possibly?

(1/1)

AshimotoK0:
Just bought one of these... hopefully to use as a rotor puller (M16x1.5 metric fine ) on smaller bikes (not 750!)  ...worth a punt for £1.90 with free  Next Day delivery !

I will just have the end face machined flat and the first couple of threads machined off. May not be hard enough ..  dunno

http://www.ebay.co.uk/itm/140745928899?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

kevski:
Should be hard enough, it's a wheel stud, just don't take too much off the end face.

Seabeowner:
Works fine for me. Used this 4 times. I've always had to bang on the end (after heating the rotor) with an ali mallet to shift them. The end is turned down to just under 10.5mm for a couple of mm.

Navigation

[0] Message Index