SOHC.co.uk Forums > CB350/400

CB400F carb. leakage

(1/2) > >>

MikeSB6:
Hello Folks,

    I'm restoring the carbs. on the seventies CB400F project and have a slow leak in them. The problem doesn't seem to be with the floats/bowls as such, but the petrol leaks over the outside of the bowls and then drips off the drain screw heads. The cast in (blank?)holes at the outer face of the outer carbs have petrol in them (the ones just above the float bowls in line with the fuel connectors between the carbs.) but I can't see if there's a leak in the holes or whether they're filling up from a leak elsewhere. Also, the carb. bores also seem to have some petrol in them, which wets the choke flaps. I've checked the floats, level pipes and float needles.

       any advice gratefully received, Cheers, MikeJ

Bryanj:
If the fuel leaks that high it suggests for a start that the drain tubes in the float bowls are blocked and the only reason for fuel to do that is incorrect float heights and or leaky float valves

MikeSB6:
Hello,

  thanks for the reply, but the overflow pipes are clear and will drain if the carbs are turned at an angle, so I don't think it's that. I've checked the float heights and the float needles are fitting o.k., so it's still a bit of a mystery,

       Cheers, MikeJ

Clem2112:
Have you checked the central fuel inlet T-pipe and the two plastic feed tubes to see if the O rings are ok?

MikeSB6:
Hello Clem,

        thanks for the reply. I don't know how to separate the carbs as they seem to be connected by a cross bar which is pinned to the carb bodies, from what I remember. Is there a way to separate the carbs without damage?

              Cheers, MikeJ

Navigation

[0] Message Index

[#] Next page