SOHC.co.uk Forums > CB350/400

Airbox to rubbers sealant

<< < (2/3) > >>

JamesH:
From my experience Honda did use a form of adhesive between the airbox and airbox rubbers (so on the external surfaces so very low chance of ingress into the engine). However, I've yet to work out what it is..

Bryanj:
James is correct as the rubbers are "glued" into the airbox. Used to use Evostick to glue the rubber rocker gasket into the DOHC motors--especially the CBX, was also a majour use for the Honda "Blue Book" Manuals (hold them down till the glue set!!)

kevski:
I have never come across this or any evidence on any of my bikes including my old 350f or 500K3.

Tazaud:
im wondering whether some clear silicone sealant would work, obviously only on the outside edge.

Clem2112:
Surely the rubber inlets design means they seal well enough  without needing any packing adhesive?

The airbox rubbers do tend to turn a bit when the carbs are pushed past so maybe it prevents that happening.

Navigation

[0] Message Index

[#] Next page

[*] Previous page