SOHC.co.uk Forums > CB750

Starter Motor Lead

<< < (2/3) > >>

philward:
Good, I've loads of m6 studding - cheers.

philward:
I've now removed the old brittle and cut starter lead then drilled and tapped M6 plus fitted copper stud. Before re-fitting I was looking to fit a new seal to the splined shaft and the O ring that seals the motor/crankcase. The seal is not listed separately and the O ring is an odd size (24.4x3.1mm). CMSL have the seal in stock but expensive plus postage - DS is out of stock.

How have other members dealt with the same issue? Should I just put it back with the old seals fitted (to be honest, that's what I did with my last rebuild)

Trigger:
Are you on about part number 91215-300-03 ? If so, I am awaiting a trade pack of those.

philward:
Hi Graham - the CMSL site lists it as 91309425003 (supersedes 91309300000)?

Trigger:

--- Quote from: philward on July 25, 2017, 10:31:02 PM ---Hi Graham - the CMSL site lists it as 91309425003 (supersedes 91309300000)?

--- End quote ---

Yes, I should have in stock by the end of the week, and not a fiver each  ;)
I think I have replaced the other spline seal but, I am sure I just measured it up and ordered the same size.

Navigation

[0] Message Index

[#] Next page

[*] Previous page