SOHC.co.uk Forums > CB750

Harness Routing

(1/2) > >>

DaveB:
CB750K6. As some might realise from other threads I'm attempting the give the bike a thorough clean - starting primarily at the front. Not at all a restoration although I am replacing parts where they seem past it and also carrying out some repairs such as to the wiring loom where the plastic sheath had complete perished around the headstock etc. I've had the ignition coils off to clean the whole area and repaired the loom but now that I'm reassembling it, pretty sure as it was, I'm not sure of the correct routing of the main loom that goes into the headlamp shell.

Should it be routed outside of the throttle cables...

[ Guests cannot view attachments ]

Or inside the throttle cables...

[ Guests cannot view attachments ]

Or have I got it completely wrong?

Unfortunately a search of this forum, the general interweb, and the manuals I have don't help.

Thank you.

Trigger:
Here is a picture of a original K6

DaveB:
Interesting. Thanks. The harness was above the tank mounting rubber when I took mine to pieces. It also seems to me it would get more easily trapped by the tank in that lower position. It seems though that the harness is 'outside' of the throttle cables, so that helps a lot. Thanks.

Trigger:
yes, the loom should go above the tank rubber.

DaveB:
Not sure I have the throttle cables routed correctly either. Wish I could find a diagram for it all such as I've seen for later bikes.

Currently the throttle cables pass by the headstock on the left, then go under the coils, entering between the 1 and 4 HT leads and staying underneath to the throttle linkages. Does this sound right or should they run along the side of the 1/4 coil?

Thanks as always.

Navigation

[0] Message Index

[#] Next page