SOHC.co.uk Forums > CB350/400

Probably been asked a million times before.......

<< < (5/5)

Bryanj:
400's are prone to bad starting if down on compression

kevski:
When i lapped mine in, i used a cocktail stick with a bit of solvol on it for the seat, and the valve fits nicely in a biro tube which i then lightly polished using a piece of stiff card which i poked a cocktail stick through and a little bit of solvol on the tip of valve and twisted the valve in the hole lightly between thumb and finger like seating an engine valve only takes about a minute.

Navigation

[0] Message Index

[*] Previous page