SOHC.co.uk Forums > CB350/400
Engine rebuild cost 400
Integra99:
Thanks Jon, I feel like I'm cheating my rebuild build not breaking into the engine but its fine and just needs a tidy up and some paint and will look and run like new.
Of course if she develops an issue later down the road we can tackle it then.. but even after a rebuild problems can occur so I'll leave alone for now!
Nurse Julie:
--- Quote from: andut on October 02, 2017, 04:05:48 PM ---Fabulous timing for a couple of 400 rebuilds !
I'm half way through my rebuild with engine stripped and cleaned, but a trip to the hospital has put things on hold for a bit, so a couple of rebuild threads will hopefully get me back into it !
Can I ask which ever one of you gets their head off first to give me a cylinder liner OD dimension please so I can check if mine is still std
Many thanks, and good luck !
--- End quote ---
I have just measured the OD of my liners and make them 56.95. At the moment I'm assuming mine are STD.
andut:
Thanks Julie, that's very helpful !
Good luck with your rebuild !
Andy
Andych:
--- Quote from: Nurse Julie on October 03, 2017, 06:39:31 PM ---
--- Quote from: andut on October 02, 2017, 04:05:48 PM ---Fabulous timing for a couple of 400 rebuilds !
I'm half way through my rebuild with engine stripped and cleaned, but a trip to the hospital has put things on hold for a bit, so a couple of rebuild threads will hopefully get me back into it !
Can I ask which ever one of you gets their head off first to give me a cylinder liner OD dimension please so I can check if mine is still std
Many thanks, and good luck !
--- End quote ---
I have just measured the OD of my liners and make them 56.95. At the moment I'm assuming mine are STD.
--- End quote ---
Sorry to resurrect an old thread but I was reading through lots of threads and happened to see where Julie measured the liner at 56.95... NOW I know why trigger doesnt like Big Bore kits.. like the 466 at 54.5mm plus clearance that leaves next to nothing on the liner... Note to self... Dont ever think of a 466 Big Bore Kit ever again..
SteveD CB500K0:
I’ll bet Jock Kerr made a kit like that. A couple of mm was as good as a mile!
Sent from my iPhone using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version