SOHC.co.uk Forums > CB350/400
CB400/4 ENGINE STRIP, ASSESSMENT AND REBUILD BY JULIE - NOW COMPLETE
Johnwebley:
--- Quote from: rockvegas400 on October 22, 2017, 11:18:25 PM ---Julie do you know what size the o rings are in your oil pump kit? I'm interested to see if I can buy them from a local supplier.
--- End quote ---
Don't bother. Support Trigger. He keeps these sohc bikes running. And at a reasonable cost
Sent from my SM-G361F using Tapatalk
Nurse Julie:
[ Guests cannot view attachments ] Have been and collected loads of blingy bits from the platers today. These are some of the nuts and bolts we had done and somewhere in this pile are the bolts from my engine, not many though as most of the ones fitted were Allen screws which I have done away with as I'm going to fit original machine screws.....all I need to do now is find the ones for my bike in this little lot :'( :'( :'(
mike the bike:
That's a nice haul, must feel like Christmas has come early.
Nurse Julie:
--- Quote from: mike the bike on October 31, 2017, 09:50:46 PM ---That's a nice haul, must feel like Christmas has come early.
--- End quote ---
It was a bit like that Mike. This was about half what we had plated this time, a very good job done by them again. I have found all of my bolts, except one of the main crankcase bolts, UBS M8 x14, I can only find 5 but I'm sure there should be 6.
paul G:
--- Quote from: Nurse Julie on October 31, 2017, 10:00:33 PM ---
--- Quote from: mike the bike on October 31, 2017, 09:50:46 PM ---That's a nice haul, must feel like Christmas has come early.
--- End quote ---
It was a bit like that Mike. This was about half what we had plated this time, a very good job done by them again. I have found all of my bolts, except one of the main crankcase bolts, UBS M8 x14, I can only find 5 but I'm sure there should be 6.
--- End quote ---
Graham will be hiding it so he can fit the last piece of the jigsaw ;) ;) ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version