SOHC.co.uk Forums > CB750
Sprsying /Painting engine
neat street:
Done mine and happy with the result. use blue tack or similar over bolt heads/nuts to cover and peel off after :)
adriangsmith:
used simonez engine enamel.
Be careful to bake it out at 200C to fully cure it. you'll find this with most engine enamels.
I've found htat curing by running the engine does not always work.
mike the bike:
That's because not all of the engine parts get hot enough.
hairygit:
--- Quote from: adriangsmith on November 26, 2017, 12:56:47 PM ---used simonez engine enamel.
Be careful to bake it out at 200C to fully cure it. you'll find this with most engine enamels.
I've found htat curing by running the engine does not always work.
--- End quote ---
So not a lot of good for the original poster's question on spraying a complete engine, as even if you could find an oven big enough to hold a complete Honda four engine, I wouldn't rate the chances of the oil seals putting up with that level of heat for long! ;)
UK Pete:
Great replys thanks, I will give it a go love the idea of bluetac on bolt heads
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version