SOHC.co.uk Forums > CB350/400
CB400 - Upper Blanking Bolt
Integra99:
Right.. engine running well.. just needed cam chain adjusting.. what I thought was am adjuster bolt turned out to be an M6 X 12mm bolt hence my cam chain was rather slack.
However where the adjuster push rod locates I'm clearly missing the blanking bolt.. I can see the end of what is the adjuster rod.. It looks like an M8 thread.. I'm assuming I can just pop a suitable M8 bolt in here?
Any ideas.. ?
Integra99:
I think this is what I'm missing...
Laverda Dave:
Yep, that's all it is. If you want to fit the correct bolt make sure you use a close fitting washer under the bolt head to ensure no debris gets in there otherwise you'll be rebuilding the engine. Personally I'd only do this as a temporary fix whilst I wait for the correct blanking bolt.
Nurse Julie:
As above.
Integra99:
Great thank you both! so its simply a blanking bolt.. really appreciate the reply and I will ensure its a tight seal.
Right on to the next problem.. !
Navigation
[0] Message Index
[#] Next page
Go to full version