SOHC.co.uk Forums > CB350/400
Spark erosion
AshimotoK0:
--- Quote from: Tomb on December 28, 2017, 01:28:48 PM ---Will a slide hammer not weld to it?
--- End quote ---
+1 that's what I was thinking ..you will get loads of localised heat too. When I did my 750K0 stud removal someone told me to smear soap on the alloy and if it goes brown then you are overdoing the heat.
Trigger:
You don't need a spark eroder on that, just weld a 8.8 bolt to it and draw it out. Or drill a hole dead centre and smack a torx bit and turn it out.
Rob62:
I think he tried all that on a previous thread.... the pin is pot-hard. Looks like a strip down and off to a specialist toolmaker / precision engineer or the like, or failing that a replacement part. :-\
AshimotoK0:
--- Quote from: Rob62 on December 28, 2017, 06:32:26 PM ---I think he tried all that on a previous thread.... the pin is pot-hard. Looks like a strip down and off to a specialist toolmaker / precision engineer or the like, or failing that a replacement part. :-\
--- End quote ---
I agree on trying to drill but I would have thought you could TIG weld to the pin...not tried it myself though so could be wrong
K2-K6:
StudLever Dent Pulling Tool: http://youtu.be/RfsonLnIJLM
What about a car body repair shop that may have kit similar to the above to get a stud welded to it?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version