SOHC.co.uk Forums > Project Board
NEW PROJECT CB750 K1
paul G:
Hi all managed to get the carbs on and all the plumbing done. ;D
Trigger:
Why are the outside carbs more blingy than the inside two ;D ;D
Rob62:
I used genuine honda inlet rubbers on my rebuild and i suffered from airleaks. Had to modify the clamps to ensure they put sufficient compression on the rubbers...clamps were gen honda too.. Not an uncommon problem either. Nice looking build by the way 8) good work!
paul G:
--- Quote from: Trigger on November 19, 2018, 09:12:09 PM ---Why are the outside carbs more blingy than the inside two ;D ;D
--- End quote ---
They aren't Graham just the camera flash ;D ;D
paul G:
--- Quote from: Rob62 on November 19, 2018, 09:18:45 PM ---I used genuine honda inlet rubbers on my rebuild and i suffered from airleaks. Had to modify the clamps to ensure they put sufficient compression on the rubbers...clamps were gen honda too.. Not an uncommon problem either. Nice looking build by the way 8) good work!
--- End quote ---
Cheers Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version