SOHC.co.uk Forums > Project Board
NEW PROJECT CB750 K1
paul G:
Bottom end rebuild started with all new bits :D
Nurse Julie:
Great progress Paul and looking oh so familiar ;D
Trigger:
Something is wrong. I have never seen the thread on con rod bolts sticking out that far after being torqued up ;)
paul G:
--- Quote from: Trigger on July 26, 2018, 12:18:11 PM ---Something is wrong. I have never seen the thread on con rod bolts sticking out that far after being torqued up ;)
--- End quote ---
Graham the crank and con rod assembley was a replacement unit from Hadley custom with less than 3k miles on it before the bike was taken off the road.
This was all on the paperwork that I received with the bike and after inspecting it there wasn't a mark on it.
I replaced the shells etc because it was prudent to do so whilst I was in there.
Trigger:
Never believe everything you read, and the threads should be level with the nuts ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version