SOHC.co.uk Forums > CB350/400

CB400 Oil Way Plug

(1/4) > >>

Deano400:
Can anyone advise on the best way to remove this plug, see pic. I am assuming it's removable as the parts manual shows it has an O ring. It feels tight and I don't want to use any unnecessary force. Does it just pull out with a bit of effort? Would like to replace the O ring when I rebuild. Cheers.

Orcade-Ian:
Yes, just pulls out and has an o ring on.
I remove them with a small 3 jaw chuck gripped around the pin and apply a little heat if needed.

Ian

Definitely replace the o ring, especially if any extra heat was needed to extract it

Deano400:
Thanks Ian great help. Like the 3 jaw chuck idea. Think I'll leave the hammer action off!!  :)

Trigger:
Remove the bung on the over side of the engine and then take a long bar and knock it out  ;)

ttr400:
What Trigger said.

Kevin

Navigation

[0] Message Index

[#] Next page