SOHC.co.uk Forums > Project Board
750 K1 project
Trigger:
--- Quote from: Crispy on May 20, 2018, 07:18:19 PM ---Yes..torqued it up as per the manual!
--- End quote ---
Well, your plasti strip is a lot cleaner than mine ;D ;D
Crispy:
Well I've only used it once!... Bet yours has been put to more frequent use!
Trigger:
I would go with those shells. Is the oil pump apart yet ? If the oil pump is at full pressure, the shells are fine.
Crispy:
Cool ...No..I haven't touched the pump yet 😬 Will do at some point though !
I'll also repeat the plastigauge measurements a couple more times just to see if I can repeat the same results.
Crispy:
Engine cases painted and cured, I can now begin to re assemble the engine. After reading older threads I'm thinking I will get the Vesrah gasket set and Honda head gasket, unless anyone has any other advice.? I am also replacing the primary and cam chains, again any advice re primary chains ? Getting the upgraded did chain ....part number ....219FTH 94LE ..which I've just spotted on another recent thread... Cheers Trigger 👍
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version