General > Out & About
OUT AND ABOUT 2018
Nurse Julie:
One bike there was stunning. It was built from boxes of bits by a chap we know who lives in our village. It's a Moto Guzzi, 1946 I think, other than that I know nothing about it at all. An absolute peach though. Edit, just worked out it is a 1949 Airone Sport 250cc. [ Guests cannot view attachments ] [ Guests cannot view attachments ]
Laverda Dave:
We went for a ride to Marlow in Bucks on Saturday. I took the Morini the O/H took the rebuilt CB250RSA to clock up the final 50 miles before it's 500 mile service.
Traffic was awful on the A40 due to the world cup so we came back on the M40 for the last 10 miles but keeping speed down to 55. The 250 siezed solid! 2 hour wait for recovery.
I begun to strip the engine down yesterday, not a pretty site. Holed and melted piston, scored barrel, scored cam and bits of piston under the valves.
Not sure what to do now, if I buy another engine I won't know its history and most engines for sale are out of the bike so buying blind. I can get the cam reprofiled and maybe try and salvage the valves or buy new and get the seats cut if damaged? I'm not sure about the crank until I get to it but likely to need new mains, maybe I'll try SEP to rebuild it, anyone used SEP?
It's a shame as the O/H loves riding the bike now she has passed her test but it looks like that's it for the Summer for her :(
K2-K6:
Wow, what a shame after all your hard work in rebuilding it.
Do you have a close picture of the spark plug tip? And which grade of plug is it? Hope you don't mind me asking.
Nigel.
Laverda Dave:
Hi Miguel, I'll dig it out when I get home, just going into London to watch the flypast. It was new and the correct plug.
The piston has done some damage to the barrel as in its scored. When I drained the oil there was about 1/2 litre but it was on the mark 200 miles ago. No leaks and no sign of burning oil either (I rode behind the O/H to check). I noticed the air box was covered in an oil mist when I stripped it and assume this was blow by as the piston melted!
I would like to rebuild this engine (again) depending on cost. Do you have any recommendations for who can rebuild the crankshaft?
Dave
Nurse Julie:
What a shame. Give Barry at T & L Engineering in Bedford a call for Crank work.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version