General > Out & About

OUT AND ABOUT 2018

<< < (46/80) > >>

paul G:

 :o :o :o :o ;) have you seen Grahams phone.


--- Quote from: Johnwebley on July 13, 2018, 09:27:51 AM ---Agree.have you got one of those mini inspection cameras?
--- Quote from: Oddjob on July 13, 2018, 09:24:56 AM ---
--- Quote from: Trigger on July 12, 2018, 11:37:10 PM ---I don't mind a trip to Spalding for a member, only 45 mins away. Always a gamble with any secondhand motor, you can't see inside the bloody things.

--- End quote ---

Top man

--- End quote ---

Sent from my SM-G361F using Tapatalk

--- End quote ---

Laverda Dave:
Graham, thanks very much for the offer to inspect the engine for me but like you say, it's always a bit dodgy buying a second hand engine. These particular engines are not the most robust either at the top end. I'm just cleaning my engine now, the damage isn't too bad considering. I can get a next up rebore of 0.50 if I can get a piston. I'll get the cam reprofiled by Newmans. The crank will need a new cobrod and I've been touch with the company recommended by Nurse Julie. Only problem so far is obtaining the r/H main bearing, the one with the undercut on the circumference, nobody has one, even CMSNL. A few companies on ebay say they have them but don't answer if I ask if they have the undercut, I suspect they are just plain bearings available anywhere. I'll keep trying, might have to get a used crank.

Trigger:
The RS250 engines were never the best of Honda's 250. You have to get a bike with a Honda KB4 engine next time  ;)

Green1:
Agree KB4 engines are indestructible.  :)

Bryanj:
As to why it happened, delving deep into the memory I remember a 400N (twin) that holed a LH piston and I rang Honda dealer Tech for advise. They said that there had been a few worldwide that although the strobe timing came up OK in the workshop were found to have been advancing too far and holed pistons. The problem was the only cure was a new alternator stator that came complete with rotor and in 83 ish cost over £300, when we checked honda parts said that due to better quality control of parts we could order just the stator under a different number for about£180---guess what, when it arrived we got bot stator and rotor for the £180.

Never had a decent reason as to what went wrong with the stators but replacement did cure it and i think the 250RS had a similar ignition system

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version