SOHC.co.uk Forums > CB750

Clutch switch diode

<< < (2/4) > >>

paul G:
If it’s like any other diode with a multi meter you will get a reading one way and open circuit the other.
Open circuit both ways bin, short circuit both ways bin ;D

Trigger:
Just dug a original switch out, two wires. Green and a Green with red.

[ Guests cannot view attachments ]



Sent from my cheap phone with shite camera, using my finger

BigAl (Alan):
Also check the clutch switch (as image) with a continuity tester, they can stick over time.

Alan

mike the bike:
Before wasting money on a diode, check with a meter.  If no meter check with the battery and a bulb.  A working diode will only conduct in one direction.

philward:
Sorry to high jack the thread! On my CR rep I'm nearly finished, I've used a new K6 loom as a basis for the CR's loom (as all the electrical bits have been re-located to the seat hump area). The CR will have all fully functioning lights (idiot lights in digital speedo) etc. and has new K2 switch gear which doesn't have the clutch switch or the 'starter motor safety switch' (on reflection shouldmhave bought K2 loom).
Question - do I just connnect the wires from nuetral and clutch input wires that woulld ordinarily go to the 'starter motor switch' (term used on online wiring diagram - diode?)
Phil

Navigation

[0] Message Index

[#] Next page

[*] Previous page