SOHC.co.uk Forums > CB350/400

Speedo Drive

(1/4) > >>

Deano400:
I'm looking for some advice on my speedo drive. I would like to strip and clean up. Has anyone got any tips on getting it apart? Little screw comes out easily enough but where do I go from there without butchering it?

By little screw I don't mean the one in the picture, it's a very small one out of view.

hairygit:
On the opposite side to what the picture shows you will find a circlip holding the large gearwheel in place, remove that and the gear wheel, and that in turn should release the spindle that drives the cable (after removing the screw you refer to) Wash all parts in something to remove all the old manky grease, dry thoroughly and check everything for wear or damage. If all okay, apply fresh grease and re assemble.

Deano400:
Thanks Hairy much appreciated.

Deano400:
Yes can see the circlip now I've removed a load of crud.

Deano400:
Circlip is out, gear wheel is out, little screw is out, but I can't get the spindle / plug out, any ideas?

Navigation

[0] Message Index

[#] Next page