SOHC.co.uk Forums > CB750
Preserving New Silencers
MarkCR750:
You could place a couple of low wattage garage tube heaters under the exhausts when you leave the bike in the garage, that would evaporate the internal moisture out quickly, but I think the best option is just to forget about it, they’ll probably last 15 years, you’ll be 85 with probably more to worry about than rusty exhausts 🙂
Moorey:
Every few tanks of fuel I add some 2 Stoke oil whether it helps or not only time will tell.
adespin:
--- Quote from: MarkCR750 on June 20, 2018, 06:11:33 PM ---You could place a couple of low wattage garage tube heaters under the exhausts when you leave the bike in the garage, that would evaporate the internal moisture out quickly, but I think the best option is just to forget about it, they’ll probably last 15 years, you’ll be 85 with probably more to worry about than rusty exhausts 🙂
--- End quote ---
That's a sobering thought :'(.
I like the suggestion of the tube heaters, i'll look into it but i will still try the Waxoyl route, the area that rots is the silencer, do they get hot enough to burn away the Waxoyl or just melt it into a liquid state which is ok.
Green1:
I have 341's on my k1 I don't look after them as well as I should.
They have been on there for 5 years and there is no rust on them the bike is used in the rain and always long journeys. 50 miles minimum.
In that time I have removed them twice to clean them properly.
What I have noticed is the left lower pipe fills with water if the bike is stored over winter on its side stand.
adespin:
--- Quote from: Green1 on June 20, 2018, 07:29:31 PM ---I have 341's on my k1 I don't look after them as well as I should.
They have been on there for 5 years and there is no rust on them the bike is used in the rain and always long journeys. 50 miles minimum.
In that time I have removed them twice to clean them properly.
What I have noticed is the left lower pipe fills with water if the bike is stored over winter on its side stand.
--- End quote ---
Thats odd !! do you think all the pipes would collect water on the main stand ?. Do you know if there is much performance difference over K1 pipes ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version