SOHC.co.uk Forums > Project Board
how do I fit a black metal number plate to my motorcycle?
SteveD CB500K0:
I assume that it’s a pressed aluminium one instead of a plastic one?
Sent from my iPhone using Tapatalk
Bryanj:
What is wrong with black plastic nuts and bolts, or white if the hole is in a number/letter.
NOTE it is now an MOT failure(and as such a Plod excuse to stop even if no MOT required) for the fixing bolts to alter the appearance of the letters/numbers
RGP750:
The double sided is more and adequate to keep it on you don't need any bolts or rivets.
Most modern cars use only this stuff,and you try getting a cracked front one off to replace it .
taysidedragon:
I see a lot of cars with no rear number plate, just some sticky pads left doing nothing! They probably didn't clean the surfaces and fit them properly, but I will 'stick' to using screws and nuts on mine. :)
Green1:
The sticky pads you see are nothing like the trim tape that RGP has highlighted if stuck properly the number plate will snap before becoming unstuck
Saying that I still bolted mine because I didn't even think about sticking it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version