SOHC.co.uk Forums > CB750

Cb750 spindle clamps

(1/2) > >>

Paulreade:
2 questions:
1. Refitting the spindle clamps am I right in thinking you fit them with the 'f' mark to the front , slightly thicker side, and clamp this up tight, then tighten the rear bolt to clamp the spindle. I cannot find the torque settings does anyone know what they are, it appears to be an8mm bolt ? Would around 18 lb ft be ok ?

2. Anyone know of a party that might offer an opinion or actually 're true' spoke wheels in the stockport/ high peak areas ?

Cheers
Paul

Erny:
Attched pic is from K7 service manual, shall be the same for all 750K I suppose

Paulreade:
Cheers erny, that's great.

adespin:
That's usefull info'

Simon46:
Manchester extreme on the A6 respoked my dt175mx.

Navigation

[0] Message Index

[#] Next page