SOHC.co.uk Forums > CB350/400

swing arm/main stand

<< < (2/3) > >>

SteveD CB500K0:
Yes he does. They are

dave400:

--- Quote from: fat lad on February 16, 2008, 08:41:52 PM ---Are these avail from dss?? if not where would i purchase such items?? cheers jonny

--- End quote ---


I don

pae:
The DSS ones will be the std Honda plastic. I managed to fit them OK, but you need a flat hard face to bash against, and you need to make sure it's on square otherwise whilst you're bashing them in the flanges will just shear off the bush.

I used a hard plastic disc. With a long M10 bolt through the centre of the disc, I put loads of tape around the bolt to make a tight fit 'spigot' that I pushed inside the bush. That kept the disc square to the face of the bush. Might have a pic if it helps.

fat lad:
Hi all got them out today they are sh*t arn't they?? got the stand tube out too, that was a really rubbish job! off to the powder coaters with all the bits now, bye for now jonny

fat lad:

--- Quote from: biffta on February 16, 2008, 09:54:09 PM ---
--- Quote from: fat lad on February 16, 2008, 08:41:52 PM ---Are these avail from dss?? if not where would i purchase such items?? cheers jonny

--- End quote ---


I don
--- End quote ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page