SOHC.co.uk Forums > CB750

750 F2 engine bars..

(1/1)

Wil:
Hi..I recently picked up some engine bars for my cb750/F2...but on trying to fit them I realized the 2 engine mounting bolts will be to short in length !!! ..is my easiest solution to just buy some longer threaded bar ? As I don't think bolts etc will work because of channel that mounting rod runs through?.. Any thoughts welcome...regards Wil.

hairygit:
Probably, or take an angle grinder and thin the mounting blocks down on the frame( DON'T DO THAT!, only kidding!)

Wil:
Lol...👍

Trigger:
I would not use threaded bar . After some years the road grit collects in the threaded part and is a nightmare to get the bars back out, if need be.
Any good engineering firm will make you a longer set of mounting bars and bolts  ;)

Bryanj:
New ones came with longer bolts and nuts to fit as the thread was different

Navigation

[0] Message Index